← All projects

ME103 · Stanford · 2026

Starting Lineup

A tactile reminder of the people who matter most while living away from home.

Role

Design and fabrication

Timeline

Spring quarter 2026

Team

Solo project

Tools

Foundry, lathe, mill, saws

Starting Lineup

Overview

Starting Lineup is my final project for ME103. Six foosball players, sand-cast in aluminum, sit on a rod between two wooden uprights, with a knurled aluminum handle at one end. Each player was cast with a name and a number. The goal was an object about meaning, experience and form: something to hold onto the people who matter most while living away from home. Foosball nods to playing soccer as a kid.

Challenge

One good casting was not enough. The players would sit side by side, so all six had to match in shape, quality and finish. Early ram-ups showed sink, broken-off sections, incomplete fills and distorted shapes. After each failure I worked out what went wrong and changed the setup: the gating, where the names sat, the pattern's orientation, and finally a riser.

“Fabrication rewards persistence.”

Pattern and gating set in the flask
Pattern and gating set in the flaskFig. 01
A raw casting, gating still attached
A raw casting, gating still attachedFig. 02

Process

I cast the players three to a flask from a pattern with the gating built in, reviewing each ram-up before the next. Seven flasks gave 21 players. The castings were then milled apart, the handle was turned and knurled on the lathe, the frame was cut and oiled in the wood shop, and the players were sandblasted.

01

Sand casting

Seven flasks, three players each, adjusting gating, name placement and orientation, then adding a riser.

02

Machining

Milled the castings apart, then turned, drilled and knurled the aluminum handle on the lathe.

03

Frame and finish

Cut and shaped the wooden base and uprights, oiled the wood, and sandblasted the players.

The six finished castings
The six finished castingsFig. 03
At the foundry furnace
At the foundry furnaceFig. 04
Knurling the handle on the lathe
Knurling the handle on the latheFig. 05
Oiling the wooden base and uprights
Oiling the wooden base and uprightsFig. 06

Outcome

The finished piece lines up six matching players between two oiled wooden uprights, with a knurled aluminum handle at one end. Six of the 21 castings met the standard I was aiming for. The project taught me sand casting, turning, knurling, woodworking and finishing, and that the second half of a build can take almost as long as the first. Next time I would start earlier.

7

Flasks rammed up

21

Players cast

6

Castings in the final lineup